HouseBot

Scott, I think I've got the problem defined. It seems that two-way is working if I use a controller (transmitter) to turn a light on or off. If I use the two-way switch itself, it does not. All the on/off events are properly tracked in the log, but there is a small difference: if the message is from...

I did as you suggested and I see that the powerlink is getting the commands - when I press the wall switch I see the log entries reporting the correct new state, but the power state in the device screen still shows the old value (and I don't see any way to force a refresh). Any idea's? Should I use ...

I've got a house full of leviton two-way controls and am now integrating HB into the mix. I can control my lights just fine, but it seems that HB is not receiving the commands when a wall switch is pressed to stay in-sync. I'm using the Powerlinc USB interface - any suggestions? (other wall controll...

Scott, I'm impressed with HouseBot and am converting my home automation system over to it (was using HCA). It would be nice if I could pass parameter(s) to a panel, paticularly the target device. I'm setting up a bunch of lights with the main on/off controls on one page and then a separate popup pan...

Was wondering if anyone has gotten HouseBot to work with the LynX-10 interface from Marrick. I've tried using the CM11a module but it's expecting a response code on statup so it's never succeed in sending commands. I'm sure the LynX-10 is quite similar to the Powerlinc (except it uses a serial port).