Client Configuration

General HouseBot discussion. Any issues that don't fit into any of the other topics belong here.
Post Reply
ckusmierz
Member
Posts: 6
Joined: Fri May 30, 2003 1:30 pm

Client Configuration

Post by ckusmierz »

If I change the IP address of the HB server how can I change the client configuration to point to the new address without waiting for a timeout?



Actually after two unsuccessful attempts the SW remote did start again in the configuration mode but I didn't seem to find a way to get there directly.
ScottBot
Site Admin
Posts: 2790
Joined: Thu Feb 13, 2003 6:46 pm
Location: Georgia (USA)
Contact:

Post by ScottBot »

You can bring up the Software Remote configuration screen by using the "/config Set" command line option.



Generally, the Sofware Remote will automatically bring up the screen if it detects that the prior connection was unsuccessful (it assumes that the connection may have been unsuccessful due to a configuration problem).



Scott
Post Reply