Page 1 of 1
Tracing task execution?
Posted: Mon Jun 11, 2007 9:07 am
by dlmorgan999
I have a task that recently started "randomly" executing. I must have changed something in my configuration but I have no idea what it could be. Is there any kind of tracing I can turn on that will tell me what caused a task to execute?
-- Dave
Posted: Mon Jun 11, 2007 7:06 pm
by dlmorgan999
I don't know if this will help but here is some additional information. Until I have time to diagnose this I disabled the task. Today after work I noticed a couple of entries in the error log stating unable to run task because the task is not enabled and the "Section" was "TCP Server". I don't know what "TCP Server" is referring to but I figured I would post it in case it was a clue.
-- Dave
Posted: Mon Jun 11, 2007 9:34 pm
by ScottBot
In this case, the "TCP Server" is the server that is communicating with a SWRemote.
If you turn on tracing for the "TCP Server", you should also see a message about which remote (by connection ID ... maybe not much help) requested to execute the task.