Page 1 of 1
Z-Wave USB Interface ZCU201
Posted: Thu Feb 14, 2008 4:51 am
by derek
I am planning on switching over from X10 to Z-Wave for lights and movement sensors. I have purchased a sample of Z-Wave 240V 50 Hz devices for testing but cannot get ZCU201 to work with Housebot. Looking through other forum posts it seems that the new model USB interface is not yet supported. Is that correct?
Error received is Can't Load Ftd2xx.dll.
Posted: Thu Feb 14, 2008 10:31 am
by ScottBot
The ZCU201 is not supported in the current installation. I am currently working on a plugin for the ZCU/ZCS 101/201 controllers.
If you are interested in beta testing it, send me an email at
[email protected] and I'll send you a copy when ready.
Posted: Mon Feb 18, 2008 12:45 pm
by JonFo
Ah, that explains it.
Scott, please drop me a copy when ready for Beta.
Posted: Mon Feb 18, 2008 8:19 pm
by ScottBot
Will do
Re: Z-Wave USB ZCU201
Posted: Sat Dec 27, 2008 8:55 pm
by derek
ScottBot wrote:The ZCU201 is not supported in the current installation. I am currently working on a plugin for the ZCU/ZCS 101/201 controllers.
If you are interested in beta testing it, send me an email at
[email protected] and I'll send you a copy when ready.
Hi Scott
Was this device included in Ver 3.2 or 3.3 as I still get the same error regarding FTD2xx.dll
Re: Z-Wave USB Interface ZCU201
Posted: Sat Dec 27, 2008 10:44 pm
by derek
I have got the ZCU-201 working using the ZWave Serial hardware interface instead of USB.
The zwave controller installed in Windows as a serial port using USB to serial driver.
Re: Z-Wave USB Interface ZCU201
Posted: Sat Dec 27, 2008 11:55 pm
by ScottBot
Great!