GC-100
Posted: Fri Sep 26, 2008 7:52 pm
Scott:
Is there any way to periodically poll the GC-100 to ensure HB has access to it. On occassion (router reset, power outage, etc.) when HB stays up and running but the GC-100 has to reconnect to the network, HB becomes unable to transmit IR signals. HB still says the hardware device is enabled but there is no joy when trying to transmit to it. Simply cycling from enabled->disabled->enabled fixes the problem....but this is a bit tough to walk a non-HB individual through over the phone. Any ideas?
Osler
Is there any way to periodically poll the GC-100 to ensure HB has access to it. On occassion (router reset, power outage, etc.) when HB stays up and running but the GC-100 has to reconnect to the network, HB becomes unable to transmit IR signals. HB still says the hardware device is enabled but there is no joy when trying to transmit to it. Simply cycling from enabled->disabled->enabled fixes the problem....but this is a bit tough to walk a non-HB individual through over the phone. Any ideas?
Osler