Page 1 of 1
Error: "Unable to parse default time span value"
Posted: Wed Jan 07, 2009 1:58 pm
by wetwired
My HBData.mdb got corrupted again. I repaired in access and all seemed fine but I get these errors during startup. "Unable to parse default time span value".
How can I fix that?
Re: Error: "Unable to parse default time span value"
Posted: Wed Jan 07, 2009 5:10 pm
by kilowatt
I have seen this error twice also. It seemed to happen if I had a power failure while a sleep timer device was running. This seems new with version 3.30. I wonder if it has to due with the changes to the sleep timer that allow us to see the remaining time.
Mark
Re: Error: "Unable to parse default time span value"
Posted: Thu Jan 08, 2009 8:23 am
by ScottBot
If I had to guess, I would say that the value of a sleep timer device isn't a valid format. So check/reset any timers you have just to make sure. It could also be related to a Task that is using a sleep timer in a condition or task list.
If you can't find it, you can send me your HBData.mdb file and I'll see if I can resolve it.
Re: Error: "Unable to parse default time span value"
Posted: Thu Jan 08, 2009 9:51 am
by wetwired
I did reset all the timers and now the error is gone. Thanks.