HouseBot

Hi all just got back from hols and housebot seems to be stuck in a loop.
If i look in the system log i keep getting globalx10 command received. HC = [J], cmd = [status request]
sending subscription notfication for list [x10 reception(all)]
and so on etc eventually get a checksum error from the cm11.
any ideas or is she dead.
Thanks Mark....

as usual the problem is me..
just wandered into the bedroom and noticed the little red light lit on the ir543 infra red receiver module. now i dont know where the ir signal was coming from or where it went to when i lifted up the module (and put it back in the same place) but problem solved.