need a little help please -housebot newbie
Posted: Tue Dec 08, 2009 6:01 pm
I am slowly finding my way around HB to the point where I have defined my cm11a com port 4 and w800 com port 1.
I have a couple of motion sensor tasks (very simple tasks right now) which are working just fine.
I can click on a device power state and change it just fine on/off.
I can't get a palmpad set to the same code as my device to work( example B6 on turns on the rangehood light).
If I plug in a tm751 set to code B then the palmpad works fine.
Any idea what I am missing ?
Neil
I have a couple of motion sensor tasks (very simple tasks right now) which are working just fine.
I can click on a device power state and change it just fine on/off.
I can't get a palmpad set to the same code as my device to work( example B6 on turns on the rangehood light).
If I plug in a tm751 set to code B then the palmpad works fine.
Any idea what I am missing ?
Neil