Page 1 of 1
Auto enable HW interface
Posted: Thu Oct 06, 2011 3:42 am
by kolesar007
Hi, I have serial device under HW interface and I like that port is on when I run HB. Is this possible, becouse now that state is remembered from last state when you close HB.
BR
Sandi
Re: Auto enable HW interface
Posted: Thu Oct 06, 2011 12:46 pm
by Richard Naninck
Not sure what you are getting at but if the last state is remembered, than if you have the serial device enabled before closing, it will be enabled after starting HB again..
Re: Auto enable HW interface
Posted: Fri Oct 07, 2011 1:05 pm
by kolesar007
I know that but I want to auto enable even if I close medio with disabled HW interface. Or if it is possible to control HW interface trough script.
Re: Auto enable HW interface
Posted: Fri Oct 07, 2011 1:27 pm
by Richard Naninck
Hardware interfaces cannot be enabled through scripts or tasks. Only through the HBServer GUI.
Why would you want to disable the interface?