Insteon Fanlic
Posted: Tue Jun 25, 2013 11:01 pm
Hi All,
I am working with the Insteon Fanlic. This is a single Insteon device (one address) that controls both a light and the fan motor. So far I am liking it and it works well with a keypadlinc.
For the fanlinc the light is on group 1 and the fan control is on group 2.
I have used the 'Insteon Single Group Controller' device for several of my keypadlincs and it works well. My problem is that I need to be able to 'send a dim command' to a group 2 device.I am pretty sure the 'insteon switch device' is hard coded to group 1 which is the light itself, but the fan is on group two and the high/med/low control of the fan is programed on fanlinc as setting dim levels.
Anyone using the 'fanlinc' with housebot? Any ideas?
Thanks much in advance!
Kevin
I am working with the Insteon Fanlic. This is a single Insteon device (one address) that controls both a light and the fan motor. So far I am liking it and it works well with a keypadlinc.
For the fanlinc the light is on group 1 and the fan control is on group 2.
I have used the 'Insteon Single Group Controller' device for several of my keypadlincs and it works well. My problem is that I need to be able to 'send a dim command' to a group 2 device.I am pretty sure the 'insteon switch device' is hard coded to group 1 which is the light itself, but the fan is on group two and the high/med/low control of the fan is programed on fanlinc as setting dim levels.
Anyone using the 'fanlinc' with housebot? Any ideas?
Thanks much in advance!
Kevin