Page 1 of 1

CG-100

Posted: Sun Aug 26, 2018 7:18 pm
by incoronado
I'm trying to use the GC-100 device using the serial interface. I am unable to assign commands and when I try sending a command using the Generic Serial Definition and I get and error indicating The format of the serial command is incorrect. It must include the ModuleID. Sorry for such a newbie question. I'm sure this is something simple I'm missing. I've attached two screenshots that might help explain.

Re: CG-100

Posted: Mon Aug 27, 2018 4:24 pm
by ScottBot
Well... in the latest version of HouseBot there is/was a bug where it wouldn't even let you assign serial commands from the GC-100. To fix that issue, here's a new interface dll that you can unzip and copy over the old one in your HouseBot/Plugins/Interfaces directory.

When you are assigning commands, they should all show a prefix in brackets that show the module number. That's what your trace is complaining about. See an example here:
gc100-sample.png
gc100-sample.png (9.66 KiB) Viewed 13650 times