Where is my type of Hardware Interface?

[Eduardo_IR]

Hello, everybody.



I´m testing a trial version of HB. I need to make an experience with a CLP wich one we use into our home automation projects, and I´m trying to interface by RS 232. But when I try to create this Hardware Interface, there´s only three types of interfaces at display: ADI Ocelot, Modem/Phone Status and X10 CM11A. Where is the Generic RS one? Is that not enabled at trial version? Does anyone have some advice for that kind of interface, will we have some problem to do that?



Thanks.

[Richard Naninck]

I remember that during install all needed interfaces need to be checked. Did you do that? For sure is that the Generic Serial Device should be available in the Trial Version. All plugins are, it is just time limited.

[Eduardo_IR]

I really did not check. What should I do to enable that type of Interface in my HouseBot?

[Eduardo_IR]

What a stupid question I made! Of course, I unninstalled the software and installed again. I saw a list of checkboxes and choosed all that I need.



Thank you for your nicest help.