Tracing task execution?

dlmorgan999 · Post by **dlmorgan999** » Mon Jun 11, 2007 9:07 am

I have a task that recently started "randomly" executing. I must have changed something in my configuration but I have no idea what it could be. Is there any kind of tracing I can turn on that will tell me what caused a task to execute?

-- Dave

dlmorgan999 · Post by **dlmorgan999** » Mon Jun 11, 2007 7:06 pm

I don't know if this will help but here is some additional information. Until I have time to diagnose this I disabled the task. Today after work I noticed a couple of entries in the error log stating unable to run task because the task is not enabled and the "Section" was "TCP Server". I don't know what "TCP Server" is referring to but I figured I would post it in case it was a clue.

-- Dave

Post by **ScottBot** » Mon Jun 11, 2007 9:34 pm

In this case, the "TCP Server" is the server that is communicating with a SWRemote.

If you turn on tracing for the "TCP Server", you should also see a message about which remote (by connection ID ... maybe not much help) requested to execute the task.