PocketPC questions
Posted: Wed Mar 24, 2004 4:56 pm
On a PocketPC, I encountered two problems:
1. I created a light indicator that shows if the light is on or off. When using the slider control and the indicator control in the same panel, the indicator does not refresh(when the light status changes), or refreshes after a VERY long time. However, if I switch to another panel and then get back, the correct status is shown. If I remove the slider control, the status refreshes on time. Is there a way to change the refresh rate of either the slider control or the indicator?
2. For some reason, the bottom of the panel is covered by the background of the PocketPC. About 1/2 cm is missing from the panel display. On some (rare) occations, the full image of the panel is displayed, and after a while the bottom gets hidden again. It is always the same part that is hidden. Any ideas?
1. I created a light indicator that shows if the light is on or off. When using the slider control and the indicator control in the same panel, the indicator does not refresh(when the light status changes), or refreshes after a VERY long time. However, if I switch to another panel and then get back, the correct status is shown. If I remove the slider control, the status refreshes on time. Is there a way to change the refresh rate of either the slider control or the indicator?
2. For some reason, the bottom of the panel is covered by the background of the PocketPC. About 1/2 cm is missing from the panel display. On some (rare) occations, the full image of the panel is displayed, and after a while the bottom gets hidden again. It is always the same part that is hidden. Any ideas?