OK, I have my IR codes setup for the volume up and down on my receiver but now I'm trying to figure out what kind of property I need to use to attach to these IR codes. I want to be able to put a button on the software remote and for each click send out the IR code. I know how to attach a remote button to a property and how to attach a property to an IR code but what type of property do I need to use to have a repeating button that will send out the volume up command.
Also (this was reported a long while back) if you try to use zone 0 on the SECU-16IR of the Ocelot the code doesn't get sent out of zone 0. If you change everything to zone 1 then it works fine. I was tearing my hair out over this one tonight.
Thanks for any help.
Eric
Volume Control
Re: Volume Control
There are different ways to go about doing this. One solution would be to:ericvic wrote:OK, I have my IR codes setup for the volume up and down on my receiver but now I'm trying to figure out what kind of property I need to use to attach to these IR codes. I want to be able to put a button on the software remote and for each click send out the IR code. I know how to attach a remote button to a property and how to attach a property to an IR code but what type of property do I need to use to have a repeating button that will send out the volume up command.
- Using the Property Manager, create a new alpha-numeric Property called Up/Down.
- Give it two discrete values (up & down)
- Add the property (right mouse click on device in tree view) to the/a device that is using your IR Hardware Interface.
- Click on the up & down property on the device and select the IR Codes tab.
- Associate/assign the up code with the IR up command configured in the Hardware Interface and the down code with the down command.
Scott