Z-wave Motion Sensor & Multilevel senor not supported ?

[parshva]

Hi Scott,

I tried installing the Z-Wave sensor device from Homeseer HSM-100 but it does not show the correct properties. Only the Level property has some numeric value from the device. The scale & type property shows this status ' Dimensionless value'. Additonally, the Door/Window Sensor from Aeon Labs always has its state to Off. I did try both these devices to perform a light on action when motion is detected directly with the z-wave binary switch device and it works like a charm..but they don't work correctly with the Housebot software.Can you please suggest any alternatives to add the required property ?

Thanks,
-Parshva

[ScottBot]

It sounds like the current version of the HSM-100 firmware is no longer compatible with the HouseBot Z-Wave sensor.

[parshva]

Hi Scott,

Your software is really cool & user friendly. Will you be adding support for these sensors anytime soon? Any release dates for these? Any workarounds to make them work as of now?

Thanks,
-Parshva

[ScottBot]

Parshva,

Sorry to say that there are no plans to add support for this in the foreseeable future.

[chrisrey]

There is no plan for the future with housebot! It sounds like housebot is dead.

[ScottBot]

Not dead. Just resting.

[chrisrey]

definitively hope so ;o) a roadmap could be appreciated!